Product presentation New Square Reflector 4723-A for 1xTC-T 18/26/32W ACL-Lichttechnik GmbH continues to expand its line of square downlight reflectors with the introdution of a horizontally-lamped model designed to hold one 18W, 26W or 32W compact fluorescent lamp. It is available in two different finishes, that means a highly specular finish (HGL GL) using a special bright and colourfree aluminium MIRO4 with a total reflection of 95% and a semi-matt finish (MAT GL). In order to improve the stability of this model, the thickness of the aluminium used is 0.75mm. This new model provides exceptional appearance and performance with a high light output ratio and reduced glare. It is designed for all environments. The following table provides an overview of the ACL standard square reflectors including the new model:       Order Codes Dimensions Lamp(s) used 4722 (S) HGL GL | MIRO4 160 x 160mm 1xTC-T 13/18W 4722 (S) MAT GL | 1500/G3 160 x 160mm 1xTC-T 13/18W 4725 (S) HGL GL | MIRO4 160 x 160mm 2xTC-T 13/18W 4725 (S) MAT GL | 1500/G3 160 x 160mm 2xTC-T 13/18W 4723 (S) HGL GL | MIRO4 195 x 195mm 2xTC-T 18/26/32W 4723 (S) MAT GL | 1500/G3 195 x 195mm 2xTC-T 18/26/32W 4723-A (S) HGL GL | MIRO4 195 x 195mm 1xTC-T 18/26/32W 4723-A (S) MAT GL | 1500/G3 195 x 195mm 1xTC-T 18/26/32W 4724 (S) HGL GL | MIRO4 228 x 228mm 2xTC-T 26/32/42W 4724 (S) MAT GL | 1500/G3 228 x 228mm 2xTC-T 26/32/42W     For further information please contact our sales staff by clicking here. We would be pleased to post you a sample as well. If you are looking for a matching square frame please have a look at our outstanding range of raw or anodised aluminium frames. Further details will be provided by our sales staff by clicking here.

Mounting instructions
How to Insert a Spring into Reflector 2674

We are continuously asked by a lot of customers how to insert our glass fixation springs into our reflector ACL order code 2674.

The procedure is as follows:
1.	Grasp the spring with thump and forefinger (forefinger touches longer end of spring) with both ends facing sideward. With the other hand grasp the reflector with the top facing the ends of the spring.
2.	Compress the spring as far as possible and push both ends diagonally through the rectangular slots (cutouts) in the flange at the reflector opening until the small opposite cutouts in the spring are located in the latitude of the slot.
3.	Rotate the spring by 45 degrees so that the longer end of the spring faces the reflector centre.

If you need further assistance to insert the spring correctly please contact our sales staff by clicking here.